Stock Tank Aquaponics, Grow Bed Construction

Stock Tank Aquaponics grow bed.

This bed is 6’x3′ by ~ 10″ tall. It is constructed with 3- 4×4’s 1 sheet of plywood & 8 – 2×4’s. I go through the process of building the base, walls & show each step along the way.

At the end I finished with putting a drain hole in one end of the bed which will have the bell siphon.

This build took about 2 hours, getting interrupted of course, next step is to put in the pond liner, cut out the spot for the drain & attach all of the fittings.

Tools Used:
Dewalt Circular Saw: http://amzn.to/2qek1ZU
Dewalt Impact Driver: http://amzn.to/2C7olvO
1 1/2″ spade bit: http://amzn.to/2CoO332

Materials list Used for grow bed (Home Depot):
15/32″ PLYWOOD – $20.65
8 – 2X4-92 5/8″ STUD – $23.12
2″ X 10′ PVC40 $8
3/4″ PVC 90 elbows: http://amzn.to/2CpMeCP
3/4″ PVC valves x 2 – http://amzn.to/2DI6v2U
2 1/2″ exterior screws: http://amzn.to/2CoClW0
2 – 3/4″ male to slip PVC: http://amzn.to/2Csd7oY
3/4″ PVC Bulkhead: http://amzn.to/2EvPI3Y
2″ PVC Cap: http://amzn.to/2CAhJqA
3/4″ PVC 45 elbows: http://amzn.to/2CtA2jy
3/4″ PVC T fitting: http://amzn.to/2CBWsgv
Pond Liner: http://amzn.to/2CvAJJe